Thread: Cheap DRO using a USB interface
-
15-12-2010 #1
Hello all,
I'm looking to build an interface between some cheap Chinese scales and a PC to use as a DRO. USB would be nice but I would settle for serial connections. I'm a VB programmer so once I get it on the PC I should be able to get the rest going.
If anyone has the interface built and needs VB programming to run it let me know and I'll try to work out a deal.
Any help would be appreciated. My mill is nearly impossible to read using the factory dials and I need a good DRO that I can count on.
-
17-12-2010 #2
Hi,
Welcome to the site, your membership has been approved and you now have full access.
Please post your questions in the correct forums for the best assistance.
Lee.Me
-
17-12-2010 #3
-
The Following User Says Thank You to BillTodd For This Useful Post:
-
17-12-2010 #4
That will get me started. Thanks again for the info.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
USB TO Parallel Port DIY Interface
By Lee Roberts in forum Electronic Project BuildingReplies: 42Last Post: 17-02-2018, 07:46 PM -
CIB Industrial Control Interface
By antsals in forum Motor Drivers & ControllersReplies: 8Last Post: 20-04-2011, 11:02 AM -
MPG Jog interface for Mach3
By HiltonSteve in forum Electronic Project BuildingReplies: 44Last Post: 24-09-2009, 07:49 PM -
HID interface for remote control of Mach3
By Smiler in forum Electronic Project BuildingReplies: 0Last Post: 10-05-2009, 12:59 PM -
Cheap for hacking
By Robin Hewitt in forum General DiscussionReplies: 12Last Post: 21-11-2008, 01:30 PM
Bookmarks