Thread: my build from the start
-
16-01-2011 #101
-
16-01-2011 #102
Oh wait. I might have misunderstood you. Are you trying to get the bed off completely? If so I'm not sure, mine just came off when I removed all the relevant bolts. I was going to scrape it...
-
16-01-2011 #103
yeh just want to take it off but can't see whats stopping it.
there is no such thing as a stupid question, just stupid answers !!!!
-
16-01-2011 #104
remove the gib strip so you can lift the table a bit and slide it over the X axis nut.
Art
AKA Country Bubba
(Older than Dirt)
-
The Following User Says Thank You to C_Bubba For This Useful Post:
-
17-01-2011 #105
thanks mate :)
there is no such thing as a stupid question, just stupid answers !!!!
-
18-01-2011 #106
only got the z axis working at the min but it helps a lot
and then there is this lol
Last edited by h4ppy-chris; 18-01-2011 at 10:00 PM.
there is no such thing as a stupid question, just stupid answers !!!!
-
18-01-2011 #107
YEEEEEHAAAAAWWW!!!!!!
yes it does beat holding the motor chris but you had two hands free, you could have held on to the Y stepper and had some of that 3 axis Action :)
-
18-01-2011 #108
steady cowboy 1 step at a time lol
there is no such thing as a stupid question, just stupid answers !!!!
-
23-01-2011 #109
useing Z & X to make the X axis motor mounting plate :naughty: its a fantastic buzz watching my mill slowly come to life
there is no such thing as a stupid question, just stupid answers !!!!
-
23-01-2011 #110
Nice - almost there!
Have you got a photo of the motor mount?
Did you use backlash compensation in that video?
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Well here we go again, start another build
By D-man in forum Gantry/Router Machines & BuildingReplies: 5Last Post: 22-01-2014, 09:59 AM -
Build log when to start posting on this site
By ramsbury in forum General DiscussionReplies: 6Last Post: 15-01-2014, 10:43 AM -
NEW MEMBER: Hello all, finally ready to start a build log.
By Iwant1 in forum New Member IntroductionsReplies: 11Last Post: 25-12-2012, 06:03 PM -
A few questions before I start my build
By eclassic in forum General DiscussionReplies: 0Last Post: 11-07-2011, 10:54 PM -
NEW MEMBER: Were do I start?!
By tonygagey in forum New Member IntroductionsReplies: 4Last Post: 07-08-2010, 07:55 PM
Bookmarks