my build from the start

[h4ppy-chris]

how do you get started! i am using autocad then lazycam.
say i have a 10x10 cm x 5mm piece of ally clamped on the mill bed, and want to put a hole in the center.
how do i set mach3 up?
.
1. load in the gcode.
thats as far as i am can you help?

[M250cnc]

how do you get started! i am using autocad then lazycam.
say i have a 10x10 cm x 5mm piece of ally clamped on the mill bed, and want to put a hole in the center.
how do i set mach3 up?
.
1. load in the gcode.
thats as far as i am can you help?

Maybe this will help

http://www.mycncuk.com/forums/showth...9965#post19965

Phil