Quote Originally Posted by i2i View Post
What's up with the original board?
I was running it quite happily on a BBC. Slow and rather frustrating at times, especially when trying to go between machine control and editing. Then one day I switched it on and it would not establish link to computor. I spent some time checking leads connections etc. I tried several desktops using win98 to XP. and software from Denford forum site all to no avail. I have just assumed that the main board was gone but no way to check. To cap it it all, I converted an emco 5 cnc to Welturn and it worked brilliantly with very little problem and just £300. I wish there was an equivalent board for Starmill. I was hoping to use existing motors' drives and PSU with perhaps Gecko 540. I have been advised that to get Toolchanger and Spindle control working with Mach 3 is hard, and I really wanted machine at least as useful as it was before. I have been putting this off for some time but using my old Victoria for some of the small componants used on my engines is def' a Walnut job! Thank you for your time. Regards Phil.