Starmill

[i2i]

converting to mach3 isn't that hard and you can still use the original drives and psu's. The toolchanger is going to be the awkward bit, but it can be done. Have you tried another bbc.

[Phil Gravett]

converting to mach3 isn't that hard and you can still use the original drives and psu's. The toolchanger is going to be the awkward bit, but it can be done. Have you tried another bbc.

No I haven't tried another BBC although I do have one.

To be honest, I think the time has come to bite the bullet and make it a better machine. As I said, the Beeb was frustrating and the software left a lot to be desired. Just two examples were that it always went back to original datum point each run, regardless of where it stopped. And you couldn't edit programs without coming out of machine control and re datuming each time. Regards Phil.