Edge Finding For Newbies

[M250cnc]

I get a piece of paper and hold it between the cutter and the job, then gently move the cutter to the job until the paper is just trapped. You can do this on the edge of the cutter and the face, for x,y, and z.

Yes i used to use a cigarette paper .001" with the spindle running, the trouble is that is very dangerous and i didn't want anyone to think i was in Jonathan & Blackburn Marks gang. :rofl:

So this is a non dangerous way of doing the same.:lol:

Phil

[i2i]

Yes i used to use a cigarette paper .001" with the spindle running, the trouble is that is very dangerous and i didn't want anyone to think i was in Jonathan & Blackburn Marks gang. :rofl:

So this is a non dangerous way of doing the same.:lol:

Phil

obviously without the spindle running.:lol: