Quote Originally Posted by Mad Professor View Post
Looks like a very handy and quick program to use.

But could you also please add, Plunge Rate, and Spindle speed.
The feed rate it prompts for applies to plunging. I'll add the spindle stuff in a few minutes.


Quote Originally Posted by M250cnc
Jonathan not dissing your efforts maybe you would be better writing wizards that are not available built in, no need to waste time reinventing the wheel.
I didn't realise that there was a similar wizard in Mach3 until after I'd written this program!

Can you think of anything that's not already in Mach3 that you would like?