Threaded View
-
15-01-2011 #1
Hi there - firstly thanks for reading this!
I'm making a DIY cnc router using some Nema23's and a TB6560 board off ebay. Z and X axis work fine, but Y-axis will only travel in one direction. I've tested the y motor on the x output and it works fine so it's not the motor wiring. I've used the multimeter to confirm I get an output from the parellel port and cable on pin 3, which according to the rubbish manual I got with the board is the Y Dir output...
I can see only two options:
1. The manual is wrong and Pin 3 is not the Y-dir input to the board - can anyone confirm this or suggest a different pin?
2. My board doesn't work!
Regards,
Martin
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
x-axis on Orac losing direction
By asto in forum Motor Drivers & ControllersReplies: 3Last Post: 29-03-2013, 01:22 AM -
1 axis tb6560 any good?
By lazzymonk in forum Motor Drivers & ControllersReplies: 15Last Post: 08-08-2012, 07:58 AM -
4 Axis TB6560 CNC Driver For NEMA17/23/34 Motor 3A on Ebay update.
By TommeyReed in forum Motor Drivers & ControllersReplies: 2Last Post: 06-03-2012, 06:01 PM -
FOR SALE: 4 Axis TB6560 Stepper Motor Driver Board
By Mad Professor in forum Items For SaleReplies: 1Last Post: 04-01-2011, 06:54 PM -
Motors and Board? Problem.
By m.marino in forum General ElectronicsReplies: 7Last Post: 17-04-2009, 10:47 AM
Bookmarks