Hacking a Roland CAMM3 PNC-3000

[mitarashidango]

Seriously, bypass the arduino/pi business, the cut down G-Code instruction set is a right hash-up and results in something you think is fine but that anyone with a decent controller wouldn't even consider.

Ok, I'll do the conversion with a decent controller.

[Robin Hewitt]

Hi Jean

I suggest I photocopy the 3 relevant sheets and post them to you.

To read the full data I had to do 25 reads on clock 1 followed by 9 reads on clock 2, this strobes the data into shift registers on the main board.

If you want it posted, send a mailing address to [email protected]

best

Robin