I will be getting some pic's up in the near future and have also loaded up some video of it cutting. Starting to get much better at the speeds and feeds for the small bits I use (largest is 6.2mm diameter). Still trying to set up the spindle control for the board with a Kress 1050 FME (the two wiring diagrams of similar boards don't quite work and don't want to blow a board). Other than that Love the system it works great and the motors run so much quieter and that is really nice (also cooler but need to wire the mains back into the E- stop to cut power and keep the boards cooler as using the EXMOD boards with the older DRV25PS boards for X,Y,Z).

Take care folks

Michael