4th Axis timing pulley + Axminster bandsaw review

[M250cnc]

I thought the bandsaw cut it quite quickly, however over the 50mm distance it was off square by about 5mm which I don't think is very good. I will check the blade tracking and guide to see if that's what caused it. Either way it's a lot quicker than cutting it by hand, though on this occasion I should have just parted it!

I think the reason you have the taper cut is due to the way you held the bar in the vice, and being to aggressive with the force of the cut.

You should have a piece the same diameter at the other end of the vice to stop the vice jaws pivoting "See Picture" and a piece of flat bar under the piece to stop it tilting.

Where has the router gone or is that in another department ?

Well done on the video.

Phil