Rotating Ballnut - design ideas

[Jonathan]

I have now cut the second pulley, and made the remaining parts for one of the assemblies except the bearing pressure plate. I immediately stuck it in the milling machine vice, put a stepper on and tested it:



Will post a video tomorrow. With me just holding the 2092mm ballscrew in one hand it did 14m/min. Almost certainly more - I didn't try.

Might be while until I finish off the other one since the tip on my parting tool became an Unexpected Flying Object. It might still be ok, but my lathe is buried in so much swarf I can't find it. It took me 5 mins to find the 60mm diameter part I had parted off, let alone a tiny tip...maybe I'll tidy it tomorrow.

[Jonathan]

I've just found this quote from John S. a long time ago:

One area where spinning ball nuts come into their own is on a CNC
lathe. ... a spin off is if you also fit a bevel gear to the nut block you can then drive this with another bevel mounted on a disengageable handwheel. This way you can
get to use a CNC lathe in manual mode without having to rely on
standing at one end turning the ball screw.

(Source: http://groups.yahoo.com/group/CAD_CA.../message/70038)

Backdriving could still be an issue, but you could add some friction to the handle and/or a lock easily enough to combat that. That's tempted me to convert my lathe ... I could probably still use my design for the router, perhaps with better (tapered roller maybe) bearings as the forces are likely to be greater. The tricky bit will be fitting the ballnut into the cross slide.

[boldford]

I've just found this quote from John S. a long time ago:



(Source: http://groups.yahoo.com/group/CAD_CA.../message/70038)

Backdriving could still be an issue, but you could add some friction to the handle and/or a lock easily enough to combat that. That's tempted me to convert my lathe ... I could probably still use my design for the router, perhaps with better (tapered roller maybe) bearings as the forces are likely to be greater. The tricky bit will be fitting the ballnut into the cross slide.

Perhaps interestingly, the George Taylor milling machines used a similar arrangement. The lead-screw being turned by the hand-wheel and the nut being turned by the self-act. http://www.lathes.co.uk/taylormiller/