Thread: Help! Moving a big lathe...
-
27-12-2015 #21
OK just done that with a Harrison m300 over a sloping lawn . First thing it WILL fall over if you are not very careful . I got mine round the back of house and bolted some very strong bits of wood through the bed held in place with strong rope. If it goes it can only go so far . Pull it on sheet metal as wood will dig in. Get people (strong not a girl) on rope either side of the lathe and use anchor points to steady it . Then pull nice and steady a bit at a time. My first go at this was about 5 years with a Colchester student and it fell over. it took a long time and a lot of effort to get it back up .Don't lift it on the lawn with an engine hoist or similar as it will sink in and the whole lot may go over Good luck .
-
Keith You do realise that this post is about 4 years old
..Clive
The more you know, The better you know, How little you know
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Moving Heavy Machine
By bobhome in forum Machine DiscussionReplies: 10Last Post: 09-09-2021, 11:41 AM -
axis not moving when running code
By geny in forum Computer SoftwareReplies: 0Last Post: 21-10-2012, 08:02 PM -
moving mach3 help please
By h4ppy-chris in forum Artsoft Mach (3 & 4)Replies: 12Last Post: 07-03-2011, 07:33 PM -
Moving a new mill
By abfa9358 in forum Milling Machines, Builds & ConversionsReplies: 5Last Post: 07-05-2010, 11:27 PM -
Vertical moving gantry????
By Ross77 in forum Gantry/Router Machines & BuildingReplies: 9Last Post: 03-06-2009, 08:34 PM
Bookmarks