Tool holders for T2 (I think) quick change toolpost

[M250cnc]

Jonathan that toolpost in the picture is 180 degrees out. :confused:

If you are doing manual then yeah you don't need too many but cnc it takes so long to set them that it is worth it in the long run.

Phil

[Jonathan]

Jonathan that toolpost in the picture is 180 degrees out. :confused:

Yes it is, didn't matter for what I was doing though! I realised what I'd done once I'd put the tool in...

If you are doing manual then yeah you don't need too many but cnc it takes so long to set them that it is worth it in the long run.

No doubt I will convert it to CNC soon.