Tool holders for T2 (I think) quick change toolpost

[M250cnc]

The trick is to make a toolplate for each job.

Well you could take longer to make the toolplate than to do the job.

Looks good, you have a surface grinder then? Or are you using a toolpost grinder in the lathe to do it?

Thanks, yes i have a Jones & Shipman 540 surface grinder, FYI a toolpost grinder would be used to grind round stock, but i have a cylindrical grinder to do that.

Any grinding on a lathe is to be done under caution that grinding dust gets everywhere if your not careful, with serious consequences.

Phil