Thread: mechatronics board
Threaded View
-
25-04-2011 #2
Last Activity: 15-03-2014
Make sure DIR X signal is working properly. Should be logic high or low depends upon settings and direction. I would borrow DIR Y or Z signal and connected to board's DIR X Signal. If works you will know that's not the board itself is damaged ,but parallel cable or port in a computer.
Hope this help
Reply With QuoteThread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
FOR SALE: Mikini 1610L CNC machining center - Mikini Mechatronics withh tooling
By Westallc in forum Items For SaleReplies: 8Last Post: 28-08-2013, 09:05 PM -
eBay: Denford Novamill SmartStep Control Board + Spindle Board
By danielbriggs in forum Items On eBay UKReplies: 0Last Post: 30-05-2013, 06:52 AM -
What board should i get ?
By Stephen-Niall in forum Motor Drivers & ControllersReplies: 4Last Post: 22-04-2012, 09:37 PM -
Tooling board
By northmeade in forum Marketplace DiscussionReplies: 2Last Post: 10-02-2012, 04:17 PM -
Breakout Board
By croy in forum Electronic Project BuildingReplies: 10Last Post: 18-08-2011, 07:50 AM
Bookmarks