. .
  1. #1
    once i get my cnc machine so i can cut panels out of 18mm 4 x 8 laminated mdf, i need to slot the edges of the panels with a 2mm kerf in the center of the edge which is 9mm down. i have seen slotter/groover router bits for doing this and was planning to slot them by hand once the panels were cut.
    is it possible to slot them on a cnc router though? i know the slotter bit is much wider compared to a normal cutting bit.
    is the solution to arrange my panels on the 4 x8 sheet cad drawing so that most of the out edge is the edge that needs slotting and i can get most of the slotting down automatically.
    or maybe set up another program where i can line up all the cut panels after they are cut on the machine and just run the slotter down the edge in a single pass, flip the panels run it again.

    does anyone know if this is a realistic possibility?
    i've never used a cnc before

  2. #2
    Quite feasable using a slotter you will have to make a jig to hold them off the table as router slotters have a nut on the end that holds the slotter blade and whatever you are cutting will have to be raised so the cutter clears the table.
    You will have to slot after you have cut your panels out of the 8 x 4 sheet.
    Trend have a biscuit slotter that you could use http://www.trend-uk.com/en/UK/trend/...ledge&id=15073
    Last edited by ptjw7uk; 02-06-2011 at 12:12 PM. Reason: url

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. edge finish - ripples and ridges
    By dsc in forum Metalwork Discussion
    Replies: 9
    Last Post: 08-07-2013, 08:53 PM
  2. 1/4" / 6mm edge finder?
    By jcb121 in forum Marketplace Discussion
    Replies: 0
    Last Post: 18-03-2013, 02:58 PM
  3. cutting a chamfered edge
    By wyndham in forum General Discussion
    Replies: 9
    Last Post: 02-07-2011, 01:02 PM
  4. is it possible to slot the edge on a cnc?
    By wyndham in forum General Discussion
    Replies: 2
    Last Post: 21-06-2011, 12:25 AM
  5. Edge Finding For Newbies
    By M250cnc in forum CAD & CAM Software
    Replies: 14
    Last Post: 01-03-2011, 10:55 AM


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts