Thread: Uniport2, PM542 and EMC2
Threaded View
-
15-07-2011 #1
Last Activity: 08-09-2018
Guys
Just fired up for first time with the above, using the charge pump on pin1 (no matter if inverted) has the drives in an on state immediate. If i switch on in EMC2 they go off. Using the force or changing the enable pins does not work either? Any ideas?:sad:If the nagging gets really bad......Get a bigger shed:naughty:
Reply With QuoteThread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
EMC2 home/limit switches... only acting as limit?
By vputz in forum LinuxCNC (EMC)Replies: 4Last Post: 15-10-2014, 09:51 AM -
EMC2 or USBCNC?
By icedfusion in forum Machine Control SoftwareReplies: 9Last Post: 12-02-2013, 04:04 AM -
g code created for M3, can it be used with EMC2
By deannos in forum Programmers CornerReplies: 3Last Post: 27-08-2012, 08:48 PM
Bookmarks