Hi guys, just wondering if I could get some help. I can't seem to get my steppers to turn via mach 3. I know the motors are wired up correctly becuase I tested by shorting enable and the simulating pulses with a link wire and they turned just fine.

I've set up the correct port and pins in mach 3 (or so I think!), but it is as if it can't see the breakout board? The emergency stop button doesn't do anything and I don't know where to start looking... I don't know if I was doing it right, but I resetted the software on mach3, went to diagnostics and it showerd all 3 enables were on. I tested between the gnd pin a pin 1 on the parallel port and got nothing? I am howerver getting around 4v on on pins 12, 11 and 10.

Cheeers