Thread: pulley ratios on 3 pulley axis
Threaded View
-
20-07-2011 #1
Ok guys just got myself very confused. I have the following configuration setup on my X axis
5mm pitch HTD15 belt used:
16 tooth pulley on stepper going to a 72 toothed pulley, on the same shaft as the 72 is a 24 toothed pulley driving the axis with matched 24 toothed idler. What by your calculations should the ratio be? Things are cutting slightly larger than expected in EMC2 :whistling:
Thanks in advanceIf the nagging gets really bad......Get a bigger shed:naughty:
Thread Information
Users Browsing this Thread
There are currently 2 users browsing this thread. (0 members and 2 guests)
Similar Threads
-
1:1 ratio - pulley sizes
By dsc in forum Belt Drive, Pulleys & TimingReplies: 3Last Post: 12-04-2014, 01:30 PM -
Cutting HTD pulley(s)
By Jonathan in forum Metalwork Project ShowcaseReplies: 2Last Post: 11-12-2012, 07:19 PM -
pulley dims for boxford csb
By onecut in forum Boxford LathesReplies: 5Last Post: 23-09-2012, 04:58 PM -
4th Axis timing pulley + Axminster bandsaw review
By Jonathan in forum Metalwork Project ShowcaseReplies: 4Last Post: 09-04-2011, 07:31 PM -
WANTED: Timing Pulley Suppliers?
By m_c in forum Items WantedReplies: 4Last Post: 02-11-2008, 01:02 AM
Bookmarks