Luke11CNC Build Log ,I'm so naïve

[JAZZCNC]

OK Jazz it's just getting clogged up with silly comments by me and doesn't look very professorial at all

James

It's not a fashion contest it's diary of your build. It's fine and the silly comments just show your excitment, just wait untill the frustrated comments appear then you'll want to delete the whole machine. . Lol

[luke11cnc]

OK I will leave it well alone

Luke is really playing on his wrist

[JAZZCNC]

Luke is really playing on his wrist

Kids who'd have em eh. . Lol

I'll try and dig the Xray out of my lads smashed wrist with pins, screws and titanium rods so you can use it as ammunition to show him it could be worse. . . Maybe also put him off expensive motoX as well if your lucky. . lol (Didn't work for my lad thou.!!)

[Jonathan]

I'll try and dig the Xray out of my lads smashed wrist with pins, screws and titanium rods

Did you get to keep the titatium? Useful stuff...

No thanks and on that note don't be playing with those capacitors.!!

If I'd known I wouldn't have shown him my wind turbine as there's lots of big magnets in that. Field is pretty enclosed so should be fine. I've since moved the big neodymium magnet I had left stuck to my lathe just in case!

[JAZZCNC]

Did you get to keep the titatium? Useful stuff...

No it's still in there replacing the smashed bit, I've threatened to remove it a few times thou. .Lol

[luke11cnc]

Cool Jazz

do you want to see a x-ray of a pace maker??

James

[JAZZCNC]

do you want to see a x-ray of a pace maker??
James

No thanks and on that note don't be playing with those capacitors.!!

[luke11cnc]

Thank's people and yes Jonathan I did see the big magnet on the lathe

I had to go for a recalibration this week as I walk through a security point and then realized it was a big magnet one

I'm so lucky it doesn't happen to often:surprised:

I was at the court house(in Leicester) paying a old old speeding fine from March

I now have 3 points on my licence and i was only going to the f***ing dentist
James

[luke11cnc]

well I've tried to get all rails and ballscrews on one plane as suggested and recommended by Jonathan but I can't

Yes yes I screwed up

my gantry is to short

so I have gone with this But I am open to suggestion



I am going to use 50x100 mm extrusion as my main support for the rails and bolted to 6" aluminium

James & Luke

[luke11cnc]

I think I have cracked it what is your views on this drawing




Extrusion 50x50 mm but the down side is they only do it in light

James & Luke