Luke11CNC Build Log ,I'm so naïve

[luke11cnc]

OK I will leave it well alone

Luke is really playing on his wrist

[JAZZCNC]

Luke is really playing on his wrist

Kids who'd have em eh. . Lol

I'll try and dig the Xray out of my lads smashed wrist with pins, screws and titanium rods so you can use it as ammunition to show him it could be worse. . . Maybe also put him off expensive motoX as well if your lucky. . lol (Didn't work for my lad thou.!!)

[luke11cnc]

Cool Jazz

do you want to see a x-ray of a pace maker??

James

[JAZZCNC]

do you want to see a x-ray of a pace maker??
James

No thanks and on that note don't be playing with those capacitors.!!

[Jonathan]

I'll try and dig the Xray out of my lads smashed wrist with pins, screws and titanium rods

Did you get to keep the titatium? Useful stuff...

No thanks and on that note don't be playing with those capacitors.!!

If I'd known I wouldn't have shown him my wind turbine as there's lots of big magnets in that. Field is pretty enclosed so should be fine. I've since moved the big neodymium magnet I had left stuck to my lathe just in case!

[JAZZCNC]

Did you get to keep the titatium? Useful stuff...

No it's still in there replacing the smashed bit, I've threatened to remove it a few times thou. .Lol

[luke11cnc]

Thank's people and yes Jonathan I did see the big magnet on the lathe

I had to go for a recalibration this week as I walk through a security point and then realized it was a big magnet one

I'm so lucky it doesn't happen to often:surprised:

I was at the court house(in Leicester) paying a old old speeding fine from March

I now have 3 points on my licence and i was only going to the f***ing dentist
James

[Jonathan]

I now have 3 points on my licence and i was only going to the f***ing dentist

Speeding to the dentist, that's a bit keen!

Jonathan make it with the extra 1 mm as we can always mill it off if needed??

I will do that.

[luke11cnc]

Speeding to the dentist, that's a bit keen!

Yes I was really poorly at Christmas (swine flu) and as a result I smashed three teeth as I hit the floor a bit to fast as I past out, But the pace maker kicked in and I came around pretty quick( go job it's working)

I also ended up in A&E at one point as I went over in the dentist (police and ambulance turned up) I felt such a fool.

The teeth cost me a small fortune £600.00 lab fee's alone glad I'm covered on denplan

James

[luke11cnc]

well I've tried to get all rails and ballscrews on one plane as suggested and recommended by Jonathan but I can't

Yes yes I screwed up

my gantry is to short

so I have gone with this But I am open to suggestion



I am going to use 50x100 mm extrusion as my main support for the rails and bolted to 6" aluminium

James & Luke