Luke11CNC Build Log ,I'm so naïve

[Jonathan]

But now I will have to wait even longer for the extra ball screw and supports to come as I've decided to add a extra ball screw to stop it creeping

Have you decided to get the next one from the same place?

as I have read on similar posts I may even up grade to stepper motors from 23 to 34's (but unsure at the moment)

I think for the size of your machine it's not neccecary. Remember that since the motor rotors are a greater diameter, their moment of inertia is much greater causing the feedrates / acceleration to be lower ... unless you use a higher voltage. For a size 34 to run effectively you would want higher voltage (mains) drivers. My machine is doubtless heavier, and I've settled with 10m/min rapid feed on the slowest axis - X. It's plenty...though I wouldn't say no to bigger motors!

I will post a image later when I have made my bed

Early night

and a excited Luke