. .

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. 28-07-2011 #6
    Jonathan's Avatar
    Lives in Leicester (Home) or Nottingham University (2nd Home), United Kingdom.
    Jonathan
    Last Activity: 05-04-2020 Forum Superstar, has done so much to help others, they deserve a medal. Has been a member for 9-10 years. Has a total post count of 3,571. Received thanks 325 times, giving thanks to others 8 times. Referred 1 members to the community.
    Also, this on is marginally cheaper and with best offer perhaps significantly cheaper?

    http://www.ebay.co.uk/itm/WATER-COOL...t_10569wt_1139

    They do vary in quality though ... there's a good thread on CNCzone about it. Er11 collets take up to 7mm, so you'll obviously be limited to 1/4" router cutters.
    Reply With Quote Reply With Quote

  2. The Following User Says Thank You to Jonathan For This Useful Post:

« Previous Thread | Next Thread »

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. The 2.2Kw Chinese Spindles - Info, Setup and Advice + More
    By Husky in forum Generic Chinese Spindles
    Replies: 222
    Last Post: 22-01-2021, 06:54 PM
  2. Chinese Spindles
    By Ricardoco in forum Generic Chinese Spindles
    Replies: 123
    Last Post: 05-12-2016, 12:16 AM
  3. motor power and chinese spindles power HELP
    By DigiSoft in forum Spindles & Drive Motors
    Replies: 5
    Last Post: 17-09-2013, 12:17 AM
  4. Chinese spindles
    By Colin Barron in forum Marketplace Discussion
    Replies: 15
    Last Post: 23-08-2011, 08:58 PM
  5. NEW MEMBER: Spindles
    By Johnp in forum New Member Introductions
    Replies: 4
    Last Post: 28-06-2009, 11:46 AM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules