Spindle holder for 1.5kw Chinese spindle.

[Peter.]

Nice design, but I don't think you were going to have any problems with the originals apart from the sharrp corners. These are tidy though.

[Jonathan]

Nice design, but I don't think you were going to have any problems with the originals apart from the sharrp corners.

I agree entirely, but most people immediately point out the sharp corner and start complaining - I though it would be best to rectify it.

Nice bit of work Jonathan.
I like the second design with the clamp at the side, nice and tidy.

Thanks...I wasn't so sure about the clamp at the side as the clamping pressure is probably less even, and if the spindle is a little too big it won't open up much. Still it's marginally quicker to cut so no problem there!