Threaded View
-
06-08-2011 #23
Last Activity: 12-04-2013
Thanks all for help and advice...!!!
No hair left James, just been told that it is genetic anyways, am currently trying to comb my eyebrows back over my forehead..!
ALL WORKING NOW...!!! New board (Uniport 2) and driver (PM542).. After a teeth gnashing week, it is finally up and running... Gotta fine tune it all and fit limit switches, but wow, more funkyness than I can handle..
Cheers
Steve..
Reply With QuoteThread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Machine Slow on Curves
By swisscheese in forum Computer SoftwareReplies: 31Last Post: 12-04-2014, 12:49 AM -
x-axis on Orac losing direction
By asto in forum Motor Drivers & ControllersReplies: 3Last Post: 29-03-2013, 01:22 AM -
Forum Slow
By pcstru in forum General DiscussionReplies: 3Last Post: 27-01-2011, 03:54 PM -
Heelp! Dual axis steppers.. Losing steps.. Pulling hair out..!
By fasteddy in forum Motor Drivers & ControllersReplies: 9Last Post: 14-05-2010, 02:32 PM -
stepper speed very slow
By jonm in forum Stepper & Servo MotorsReplies: 17Last Post: 02-11-2009, 12:39 AM
Bookmarks