Post processor Sei

[Swarfing]

No worries i'm not an expert either but there always ways round things. the two options i see you have is either convert your code? or change the machine control software? have you looked at either of these? Do you have enough information about the components setup of your machine? what motors is it using? what controller (drivers) does it have screw sizes etc

[2006Nobull]

I do have a manual with some data in it. All the parts seem to relate to Sei parts numbers rather than what sort of drivers screws etc. I think the motors are steppers with encoders fitted and it's fitted with a 3 phase industrial spindle.
It does say in the manual that data is transmitted in ASCII if that means any thing to you. To be honest I won't have a clue how to change the operating software or change the code.
I had hoped that I would be able to muddle may way through learning from my mistakes but I don't seem to be able to get to the stage where I can make mistakes.

Thanks, for your interest,
Paul