Thread: wiring for drag chains
Threaded View
-
01-08-2011 #3
CY is ok for drag chains but does suffer from breakage over time. I have replaced loads of the stuff over the years. Give it a good stretch before you install it and make sure it is firmly secured at both ends of the drag chain so that it doesnt pull itself into the drag chain and start to coil up with the repeated movement. Also be careful
about how you unwind the cable before installation. Roll it from the drum so that it doesnt twist.
Ian
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Drag Knife anyone?
By JoeHarris in forum Tool & Tooling TechnologyReplies: 22Last Post: 07-11-2019, 08:32 PM -
Cable drag chain
By birchy in forum General ElectronicsReplies: 9Last Post: 04-01-2014, 12:45 AM -
Drag Chains
By Mad Professor in forum General ElectronicsReplies: 3Last Post: 30-04-2013, 11:23 PM -
Drag chains
By jcb121 in forum General DiscussionReplies: 4Last Post: 14-05-2012, 11:44 AM -
Spring loaded drag engraver
By Sharx in forum Tool & Tooling TechnologyReplies: 1Last Post: 16-02-2011, 11:10 PM
Bookmarks