Thread: Taking the plunge again!!!
Threaded View
-
07-08-2011 #1
:naughty: Ok Im looking to buy another mill to convert, Ive decided my Boxford 260 vmc is almost ready to go.
Im looking for one similar to the picture below, New OR Second Hand, if you know of any similar mills on the net. please post the link, or if you have one let me know..
Im looking for Cross travel: > 150mm & Longitudinal travel: > 420mm
I would like an R8 taper (but would consider others) as I will be converting to ATC.
RickAlways bear in mind that your own resolution to succeed is more important than any other - Abe Lincoln
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Will this end-mill plunge?
By Tenson in forum Tool & Tooling TechnologyReplies: 10Last Post: 26-02-2013, 04:40 PM -
BUILD LOG: taking the back off a stepper
By blackburn mark in forum DIY Router Build LogsReplies: 10Last Post: 06-10-2012, 08:12 PM -
this site is taking a long time load or refresh pages
By deannos in forum General DiscussionReplies: 6Last Post: 15-12-2011, 10:00 PM -
Taking this route for spindle
By GeorgeD in forum Gantry/Router Machines & BuildingReplies: 9Last Post: 25-08-2010, 09:23 AM -
Taking the plunge
By Robin Hewitt in forum Computer SoftwareReplies: 0Last Post: 14-05-2010, 01:22 AM
Bookmarks