Thread: Taking the plunge again!!!
Threaded View
-
12-08-2011 #4
I'm not sure about the pillar either, so I'm looking for peoples experiences with this type of mill and so far Ive looked at 2217-30 that has the bigger motor and drilling and end milling capability than the 2217-III LV,and HOSS from CNCzone has done a conversion of the Grizzley G0704 (Equiv To 2217-III LV) and that shows some of the limitations and fixes of that model, and Ive heard the 9525 trashes the motor controller and gearbox very easily but it does have a better X-Y i think., they both have the common plastic gears.. so im hoping people will put their thoughts in on these and indeed other models of this type..
Always bear in mind that your own resolution to succeed is more important than any other - Abe Lincoln
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Will this end-mill plunge?
By Tenson in forum Tool & Tooling TechnologyReplies: 10Last Post: 26-02-2013, 04:40 PM -
BUILD LOG: taking the back off a stepper
By blackburn mark in forum DIY Router Build LogsReplies: 10Last Post: 06-10-2012, 08:12 PM -
this site is taking a long time load or refresh pages
By deannos in forum General DiscussionReplies: 6Last Post: 15-12-2011, 10:00 PM -
Taking this route for spindle
By GeorgeD in forum Gantry/Router Machines & BuildingReplies: 9Last Post: 25-08-2010, 09:23 AM -
Taking the plunge
By Robin Hewitt in forum Computer SoftwareReplies: 0Last Post: 14-05-2010, 01:22 AM
Bookmarks