Thread: Taking the plunge again!!!
Hybrid View
-
13-08-2011 #1
Well as i said there is a shed load of pictures on this site and the complete SPG 2217 (well its equiv anyhow) CNC Conversion...
http://www.g0704.com/index.html
It really is a very entertaining and detailed conversion. I suspect i will do the same on here as soon as i make the decision.Always bear in mind that your own resolution to succeed is more important than any other - Abe Lincoln
-
13-08-2011 #2
Maybe even making a thick plate full length shroud around the pillar that could be fixed to the extended base.
-
13-08-2011 #3
It sounds like a great idea, im not sure if i would extend the y axis like hoss did anyhow as i may be going for the 9525 which has a better x and y anyhow, as i understand that you lose a little when you cnc it. Im thinking that re-inforcing the pillar is the way to go on either model.. it is chinese after all... It would be real nice if i could just buy the carcass as im going to rip out most of the stuff thats in it any how
Always bear in mind that your own resolution to succeed is more important than any other - Abe Lincoln
-
13-08-2011 #4
what is the physical length of the 260 table.
-
13-08-2011 #5
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Will this end-mill plunge?
By Tenson in forum Tool & Tooling TechnologyReplies: 10Last Post: 26-02-2013, 04:40 PM -
BUILD LOG: taking the back off a stepper
By blackburn mark in forum DIY Router Build LogsReplies: 10Last Post: 06-10-2012, 08:12 PM -
this site is taking a long time load or refresh pages
By deannos in forum General DiscussionReplies: 6Last Post: 15-12-2011, 10:00 PM -
Taking this route for spindle
By GeorgeD in forum Gantry/Router Machines & BuildingReplies: 9Last Post: 25-08-2010, 09:23 AM -
Taking the plunge
By Robin Hewitt in forum Computer SoftwareReplies: 0Last Post: 14-05-2010, 01:22 AM
Bookmarks