1st Build, Second machine

[Jonathan]

Ok obviously miss understanding but either way flimsy or strong it's fact the rails would help support.!

Of course, but if it's helping significantly you're probably doing something wrong.

First let me say dont be fooled by the lack of post's, I've been building diy cnc machines both for my self and others for meny years so I know very well all the newbie mistakes and pitfalls I just havent posted on here.

I've read plenty of your posts on CNCzone. Well, I'm pretty sure it's you. It is obvious from the few posts that you have made here that you know what you're talking about! I have not posted on CNCzone since 5 years ago as I figured I would never have time to do any machining if I did it too much.

Regards the down side and your thinking you have to move the steppers with the front plate. It makes no differnce rails on rear or front both you can still have the motor static with the right design. Your right thou the difference is negliable.

Fair enough, me not thinking...

When using Profiled linear rails it's important you have a datum referance edge but not for helping stopping them move when crashed, the main importantance is for the alignment when installing.

Agreed, the more important factor is to attain good alignment of the rails. It also explains why the sides of the bearing blocks are ground. The reason I said about stopping movement after a collision is that I remembered reading it here, page 13 where it mentions that 'it is possible that the rails and the blocks will be displaced when the machine is subjected to vibrations and impacts':

http://www.hiwin.nl/DownloadCenter/f...9TE14-1006.pdf

Then you tighten the opposing or what I call floating rail or bearing losely then slowly move the gantry or table along the rail nipping the bearing or rail as you go along feeling for any tight spots and losening adjusting the floating rail or bearing to eliminate tight spots

That's what I did and subsequently checked it with a dial indicator.

I won't pretend to be any sort of expert on profile rails - I've only just researched them and bought mine. I still may get some for my X-axis (2000mm rails). I gather you know of a good source?

[JAZZCNC]

Agreed, the more important factor is to attain good alignment of the rails. It also explains why the sides of the bearing blocks are ground.

Also Jonathan If you look carefully the rails are ground or have ref edge not just the blocks. . . Very easy to miss.!

[JAZZCNC]

Here ya go Lads. . . I knew I had some pics of a Z axis I'd made (really should take more pics of stuff made!!) that used linear rails on front plate with stationery motor, Also with pockets for bearings to give datum ref and slightly recovers some lost stick-off.!

It also inverts the stepper and drops it down the backside out the way connecting to screw with belts and pulleys. The number 1 looking bit in the pics is for a drop down bracket that attach's to the y axis screw.

Also a pic showing the Yaxis stepper again inverted in on it's self, reason being this machine was designed for small spaces or sheds so wanted to minimise foot print and eliminate any sticking out bits, The X axis does the same with everything under the bed out the way. . . Nothing protudes past the frame foot print.



In the pic showing rails n bearings they are just lent against the backplate for the pic, the bearings actually go to the bottom of the back plate. They also need cutting to length. . . . . ( Jonathan those are 20mm SBC bearings n rail.)