1st Build, Second machine

[JAZZCNC]

Due to problems (flex of Y axis and Z axis dropping up to 1.5mm from a set position)

The Zaxis dropping most likely won't be due to weak design problem but more probably an electrical problem, possibly a weak or under powered motor thou you'll still have the same problem if not changed.

Other than what marks pointed out then there's not much more to see or say.

[m.marino]

Okay but then comes placement of the lead screw, as don't have the funds for a new ballscrew at present. Folks I am really aprreciative of your input it is just that I have a rather large amount of work that I have been finishing that was supposed to go to this convention for clients who are interest and some that are closed sales IF I get the product there.

Again thanks and will try to get some revised drawings up later tonight.

Michael

[blackburn mark]

but then comes placement of the lead screw, as don't have the funds for a new ballscrew at present.

which one Z or Y screw? i thought you already had them??.. they will already be as long as they are :heehee:


there are ways of squeezing them in