1st Build, Second machine

[m.marino]

Well Folks here is the promised video of some of the Test bed running I did today. This video takes it up to 4m/min run speed going in 500mm/ step ups from 2500mm/min start. I do not have video of the 5m/min run I did after that as was very careful with that one as did not want anything to wrong so had one hand on the e-stop and the other checking as able to do safely to insure nothing was over heating. Already have done a light tightening of the belts as was expected to be needed. I am going to be ordering the HDPE tomorrow for the cutting area bed and also a surfacing bit to surface it with (any suggestions up to a 8mm shaft would be useful (don't have 7mm collet but do have 1/4"). Then it is cutting jigs and parts. I will be posting more video as able.

http://youtu.be/V1NJ9zSP53o

Enjoy.

Michael

[motoxy]

More fun than a train set eh! Well done Michael its looking good. I will pop in during the week.

Bruce

[JAZZCNC]

:dance::dance::dance: No sweeter sight than seeing a machine come to life :dance::dance::dance:

Only wish I could have been there to see the BIG CHEESY smile on your face.! . . ENJOY. .