1st Build, Second machine

[m.marino]

Folks video of it cutting:http://youtu.be/dDnCwK3TLkc and here: http://youtu.be/T7EW02Mux_Q and here: http://youtu.be/wO1KkYz9oOU

Hope you folks enjoy. Will be getting a new 2mm acrylic end mill as one broke in the cutting of this project ( piece was able to get free and bind the endmill.

Will keep folks posted as thing continue.

Michael

[m.marino]

Well a small but important update.

Home and limit switches cut and installed. Tuning of the motors now within needed tolerances (.02mm or less, repeatable), going to be tramming the spindle tomorrow as that needs to be done for doing large surface cutting. Then it is time to cut and cut and cut. I might not be on often for a week or two as I get all the cutting done, but will try to post some more video.

Again thanks to all the folks that helped with this.

Michael