Threaded View
-
11-08-2011 #1
Good day all.
I would like some help and advice with regarding to wiring up my new M60STH88-3008DF Stepper Motors to my PM752 Stepper Drivers.
Is it best to wire the steppers in Parallel or Series mode.
My understanding is that it's best to wire the steppers in parallel mode for more speed.
And I am having problems following the stepper motor data sheet on how to wire the steppers to my drivers.
PM752 Stepper Driver Output
A+
A-
B+
B-
M60STH88-3008DF Stepper Motor Wires
A+: Blue/White
A-: Blue
C-: Red/White
C+: Red
B+: Green/White
B-: Green
D-: Black/White
D+: Black
I was looking at wiring the steppers and drivers as follows.
A+ > Blue/White & Red/White.
A- > Blue & Red.
B+ > Green/White & Black/White.
B- > Green & Black.
Can anyone please confirm if this is right?
Thanks for your time.
Best Regards.Last edited by Mad Professor; 11-08-2011 at 01:25 PM.
"If first you don't succeed, redefine success"
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Matching Drivers with Steppers
By hoppo in forum Motor Drivers & ControllersReplies: 4Last Post: 21-11-2012, 01:19 PM -
Optimum voltage for M60STH88-3008DF steppers and 752 drivers?
By Mad Professor in forum Stepper & Servo MotorsReplies: 6Last Post: 26-08-2012, 09:38 PM -
Any one used drivers and steppers from CNC4you
By sebring115 in forum Motor Drivers & ControllersReplies: 14Last Post: 30-11-2011, 11:32 PM -
Has anyone used these steppers or drivers?
By Jonathan in forum Stepper & Servo MotorsReplies: 2Last Post: 24-03-2011, 02:24 PM -
Steppers and drivers
By Davidh in forum Motor Drivers & ControllersReplies: 3Last Post: 12-06-2009, 05:59 PM
Bookmarks