Threaded View
-
20-08-2011 #1
Hi
I've finally go back to building the hot wire cutter but I'm struggling to get the lead screws which are M10x1.5 thread rod connected to my stepper motors. I basically need to get one end turned down to 1/4" to match the motors. Does anyone know of anybody in the Rotherham area with a lathe that can do this. I don't mind paying for it as long as its reasonable
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
quick question about lead screw
By japcarmaniac in forum Gantry/Router Machines & BuildingReplies: 2Last Post: 09-02-2013, 11:25 PM -
timing belt instead of lead screw
By deannos in forum Gantry/Router Machines & BuildingReplies: 28Last Post: 06-03-2012, 08:25 AM -
one lead screw or two
By johngoodrich in forum Gantry/Router Machines & BuildingReplies: 10Last Post: 13-08-2011, 02:39 PM -
x-axis rails and lead screw
By adambrum in forum Gantry/Router Machines & BuildingReplies: 1Last Post: 13-08-2011, 01:56 PM -
Lead screw and drive nuts ?
By Kammo1 in forum Gantry/Router Machines & BuildingReplies: 8Last Post: 04-11-2010, 10:46 AM
Bookmarks