Mounting motor under table?

[Jonathan]

Ok just for jonathan Here's what 10mm pitch gets you.!!

Was amazed when I first saw that - I still am.

Jonathan if you want the code your welcome to it, or any body else for that matter. It's a 17mb file thou and over a million lines of code, If I remember correct it took about hour n half.

Yes please! I've got some aluminium that size so why not...I believe you did it with a 6mm spot drill, 90°? As better excuse than most to finally buy some spot drills I guess.

I agree that 10mm pitch is definitely the way to go if you want good feed-rates.

[JAZZCNC]

Was amazed when I first saw that - I still am.

Ye me too I must have looked at it for days and every time I saw a bit more detail I'd missed.
It's also mesmorizing to watch the toolpath do it's stuff the bloody thing bounce's all over the place, so much so when first started cutting I very nearly stopped it because I thought it had FUBARD.

Yes please! I've got some aluminium that size so why not...I believe you did it with a 6mm spot drill, 90°? As better excuse than most to finally buy some spot drills I guess.

No better excuse IMO. . lol . . . . . I'll dig it out and send your way.