Thread: Diy Brushless Spindle
-
01-11-2020 #181
Hi all
would this be any good as the motor, it has 10mm shaft and 200kv. I found a spindle that is 10mm URL="https://www.amazon.co.uk/dp/B07Q7473NH/?coliid=I1PB48BH2P8JSU&colid=1WM4D42BOQDI4&psc=1&r ef_=lv_ov_lig_dp_it"]https://www.amazon.co.uk/dp/B07Q7473NH/?coliid=I1PB48BH2P8JSU&colid=1WM4D42BOQDI4&psc=1&r ef_=lv_ov_lig_dp_it[/URL]
any other good ones around
Ta D
-
08-06-2021 #182
...I know it has been 10 years since the thread started... just wondering if somebody could make me one like Mark's with double bearing ?
I fancy doing a small drill press like this one -> https://www.youtube.com/watch?v=T-ieUwOoqgw
This will be used for drill wood and occasionally acrylic/ aluminium so maybe maximum of 4000 rpm.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Denford router - Brushed router too brushless spindle - Help and advice please
By Tom B in forum Brushless Spindles & MotorsReplies: 4Last Post: 16-05-2016, 09:13 AM -
All-In-One Brushless Servo System
By Gytis in forum Stepper & Servo MotorsReplies: 0Last Post: 22-12-2015, 10:21 PM -
DIY Brushless spindle
By booski in forum Brushless Spindles & MotorsReplies: 2Last Post: 30-10-2013, 09:36 AM -
Using RC Brushless motors as spindle
By Jonathan in forum Brushless Spindles & MotorsReplies: 30Last Post: 20-12-2012, 08:51 PM -
Mach 3 control of DC Brushless motor?
By templecorran in forum Artsoft Mach (3 & 4)Replies: 15Last Post: 18-11-2010, 04:20 PM
Bookmarks