Hi Guys...

I've just started to build my router again after a years lay off (got into RC Helis which I fly in B'burn which ate/eats up all my money and sparetime) and have a servo tester (for setting the CCPM swash on the heli up) and spare a few spare ESCs so this is looking interesting!! To start with I'm only looking to cut balsa and ply but as time goes on I'll want to cut plastic and maybe some Ali (when I've made mods to my router.) What would your suggestions be for motor etc? I was thinking of something a little smaller than yours, something like http://www.giantcod.co.uk/xyh5065-27...-p-404605.html with a http://www.ebay.co.uk/itm/C8-ER11-10...item2567df6da9 we have an old Colchester Bantam lathe at work so could have a go at the bearing housing...

Cheers, Neil.