Thread: Diy Brushless Spindle
Threaded View
-
26-10-2011 #10
Thanks for the info Mark I'll have a look at that one. Instead of cheap skate bearings could I not use a single double row AC bearing, would I have to pre-tension it? Saying that I've skate bearings coming out of my ears as I'm planning on using them as the linear bearings on all my axis ;) The only problem I can see for me is making the bearing housing, I looked at our lathe this morning and the tooling is crap as it's only used to take the raised face off flanges etc, not sure when it last had a service either. Will get some Ali bar offcut and have a play I think. Hope it's ok as I was planning on machining my leadscrews on it!
Thread Information
Users Browsing this Thread
There are currently 10 users browsing this thread. (0 members and 10 guests)
Similar Threads
-
Denford router - Brushed router too brushless spindle - Help and advice please
By Tom B in forum Brushless Spindles & MotorsReplies: 4Last Post: 16-05-2016, 09:13 AM -
All-In-One Brushless Servo System
By Gytis in forum Stepper & Servo MotorsReplies: 0Last Post: 22-12-2015, 10:21 PM -
DIY Brushless spindle
By booski in forum Brushless Spindles & MotorsReplies: 2Last Post: 30-10-2013, 09:36 AM -
Using RC Brushless motors as spindle
By Jonathan in forum Brushless Spindles & MotorsReplies: 30Last Post: 20-12-2012, 08:51 PM -
Mach 3 control of DC Brushless motor?
By templecorran in forum Artsoft Mach (3 & 4)Replies: 15Last Post: 18-11-2010, 04:20 PM
Bookmarks