Quote Originally Posted by Villacherman View Post
I would also load the angular contact bearing in the same orientation (both loaded with "upward" force). This would make the bearings strong in plunge operations, but weaker in operations where the bit is moving up out of the work piece. Would this be a problem though? Most operations are pressing into (down) the work piece.
on most occasions your tool would be pulling down as you are cutting but as i have said above, get some tension in those balls and and loctight your nose bearing and you should be fine

bearing heat may be an issue if your running above 10000rpm (keep an eye on the temp though as it may take a while for your bearings to settle in) if your cutting plastics and pcb's and your not in a crazy arsed rush then 10000rpm is a tad fast... i cut acetal at between 2000rpm and 4000rpm (6mm 3mm tooling) im sure i read somewhere that anything up to 110 degree C and your ok .... mine dont get anything like that hot

the small engraving spindle i made gets pretty hot when i run it above 30000rpm so i tend to run it closer to 20000rpm , i dont run that one very often so its hard to say how long the bearings will last?