. .

Hybrid View

Previous Post Previous Post   Next Post Next Post
  1. 26-10-2011 #1
    njhussey's Avatar
    Lives in Gloucester, United Kingdom.
    njhussey
    Last Activity: 03-01-2025 Has been a member for 9-10 years. Has a total post count of 1,375. Received thanks 127 times, giving thanks to others 89 times.
    Just bought 2 off 2" dia x 50mm bits of Ali.....one to mess about with and the other to do the propper job :whistling:

    I was going to get them and then spend the time whilst they wing their way from the US looking at ways to do it :-)
    I'd best get started then as just been informed that they've been shipped
    Neil...

    Build log...here
    Reply With Quote Reply With Quote
  2. 26-10-2011 #2
    blackburn mark's Avatar
    Lives in blackburn, United Kingdom.
    blackburn mark
    Last Activity: 24-03-2022 Has been a member for 9-10 years. Has a total post count of 604. Received thanks 28 times, giving thanks to others 28 times.
    Just bought 2 off 2" dia x 50mm bits of Ali.....one to mess about with and the other to do the propper job :whistling:
    hahahahahaha!!!!!! i think me n you might have been separated at birth :rofl:
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Thread Information

Users Browsing this Thread

There are currently 29 users browsing this thread. (0 members and 29 guests)

Similar Threads

  1. Denford router - Brushed router too brushless spindle - Help and advice please
    By Tom B in forum Brushless Spindles & Motors
    Replies: 4
    Last Post: 16-05-2016, 09:13 AM
  2. All-In-One Brushless Servo System
    By Gytis in forum Stepper & Servo Motors
    Replies: 0
    Last Post: 22-12-2015, 10:21 PM
  3. DIY Brushless spindle
    By booski in forum Brushless Spindles & Motors
    Replies: 2
    Last Post: 30-10-2013, 09:36 AM
  4. Using RC Brushless motors as spindle
    By Jonathan in forum Brushless Spindles & Motors
    Replies: 30
    Last Post: 20-12-2012, 08:51 PM
  5. Mach 3 control of DC Brushless motor?
    By templecorran in forum Artsoft Mach (3 & 4)
    Replies: 15
    Last Post: 18-11-2010, 04:20 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules