. .

Hybrid View

Previous Post Previous Post   Next Post Next Post
  1. 04-03-2017 #1
    dlang's Avatar
    Lives in Simi Valley, United States.
    dlang
    Last Activity: 04-03-2017 Has been a member for 8-9 years. Has a total post count of 2.
    did you attache the stub directly to the motor? or did you build bearings between them?
    Reply With Quote Reply With Quote
  2. 04-03-2017 #2
    GordonFreeman's Avatar
    Lives in Madison, United States.
    GordonFreeman
    Last Activity: 06-03-2017 Has been a member for 7-8 years. Has a total post count of 5.
    I put 2 additional bearings on the stub and then a coupler from the stub to the motor. It's all held together by the casting. Everything lines up good, I just made a solid couple (no flex) hopefully that will be ok. Can't wait to try some actual work with it.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Denford router - Brushed router too brushless spindle - Help and advice please
    By Tom B in forum Brushless Spindles & Motors
    Replies: 4
    Last Post: 16-05-2016, 09:13 AM
  2. All-In-One Brushless Servo System
    By Gytis in forum Stepper & Servo Motors
    Replies: 0
    Last Post: 22-12-2015, 10:21 PM
  3. DIY Brushless spindle
    By booski in forum Brushless Spindles & Motors
    Replies: 2
    Last Post: 30-10-2013, 09:36 AM
  4. Using RC Brushless motors as spindle
    By Jonathan in forum Brushless Spindles & Motors
    Replies: 30
    Last Post: 20-12-2012, 08:51 PM
  5. Mach 3 control of DC Brushless motor?
    By templecorran in forum Artsoft Mach (3 & 4)
    Replies: 15
    Last Post: 18-11-2010, 04:20 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules