Thread: router jumping position
Threaded View
-
22-09-2011 #4
Last Activity: 04-08-2022
its a routout cnc breakout board. velocity set to 2000mm/min max. accellleration is set to about 0.25 seconds. the rest of the progrm ran fine it was just this one bit that did it so i don 't think the velocity/acceleration is a problem hopefully
Reply With QuoteThread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Spindle position sensor
By GeoffV in forum Motor Drivers & ControllersReplies: 3Last Post: 23-03-2014, 10:00 PM -
Machine tool transporters that will move machines into position
By komatias in forum Marketplace DiscussionReplies: 6Last Post: 09-08-2013, 07:27 AM -
Mach3 Tool Change Position
By Mad Professor in forum Artsoft Mach (3 & 4)Replies: 7Last Post: 15-07-2013, 06:54 PM -
Position feedback
By D.C. in forum Electronic Project BuildingReplies: 4Last Post: 17-10-2012, 11:30 AM -
Manual Miller Position, Bracknell
By GMNOCNC in forum Opportunities Available & SoughtReplies: 0Last Post: 23-03-2011, 07:46 PM
Bookmarks