Thread: newbie with a tool id question
Threaded View
-
02-10-2011 #2
Last Activity: 23-09-2017
Correct.
MT4 taper with a capacity of M14 to M33 and the three tap holders are for M22, M24 and M27 possibly a tad to big for 6BA
See here.
http://www.machine-tapping.co.uk/tap...ap-collet.htmlJohn S -
Reply With QuoteThread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Newbie computer hardware question
By chris in forum Computer HardwareReplies: 4Last Post: 16-01-2014, 05:12 PM -
NEW MEMBER: Newbie - question on bit types
By Steven W in forum New Member IntroductionsReplies: 2Last Post: 16-05-2013, 12:06 PM -
FK12 BEARING, tighten on lead screw first - newbie question?.
By Mark Snape in forum Lead Screws, Nuts & SupportsReplies: 4Last Post: 08-03-2012, 10:59 AM -
What tool would you use for this?
By Kai in forum Tool & Tooling TechnologyReplies: 1Last Post: 21-03-2011, 06:08 PM -
Newbie Question ...
By Wobblybootie in forum General DiscussionReplies: 1Last Post: 03-12-2009, 05:32 PM
Bookmarks