Ok...

Seems my run of bad luck is continuing..! Got an EP002G1 psu from a fellow forum member, but I have measured 58.8v output unregulated..! I know this is much higher than it should be (42-46v on the spec sheet).
This is too much for the drivers I am using which are limited at 50v (already blown one of them).. I know there are many out there that have these psu's and am wondering if there is anything I can do to 'dial' down the voltage? Will pop the cover off a bit later and see if there are any pots but this is like letting a road digger perform brain surgery and I would prefer some advice before rummaging around in it..

Steve..