Quote Originally Posted by fasteddy View Post
You set the the PSU for two outputs, 65v 8amps which I am pretty sure is fine for those motors.. Yes please, if you can send me a replacement rectifier, I will solder it on.. The -ve wire is also crispy so will replace that too..
Ok, I've got a few 35 amp ones lying around which should do the trick.

I'm a bit worried now you appear to be using this power supply with the PM542 drivers? I thought is was PM752. If that's the case it's bad as those drivers are only rated for 50V. I'll check in our emails what voltage the transformer actually is/was.

EDIT: Nevermind, that's me being an idiot...it's the PM752 so not a problem.
I really need to go now.