. .

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. 20-06-2016 #10
    JAZZCNC's Avatar
    Lives in wakefield, United Kingdom.
    JAZZCNC
    Last Activity: 19-01-2024 Forum Superstar, has done so much to help others, they deserve a medal. Has been a member for 9-10 years. Has a total post count of 8,446. Received thanks 1,445 times, giving thanks to others 109 times.
    Neal they are separate grounds but you don't need 5 core 4 cores is enough. Heres how you wire it to IP-M controller.

    Starting with On/OFF. Take DCM to Pin 25 then FWD to Pin 12 or 13 depending which Output relay you want to use.
    Speed Control: ACM to Pin2 on Analog Output. V1 to Pin1

    It's that easy.
    Reply With Quote Reply With Quote

  2. The Following 4 Users Say Thank You to JAZZCNC For This Useful Post:

« Previous Thread | Next Thread »

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. help connecting a pot to huanyang vfd 2.2
    By edgas10 in forum General Electronics
    Replies: 15
    Last Post: 14-08-2016, 06:45 PM
  2. Huanyang VFD control plugin for Mach3, USB RS-485
    By JayPunchbuggy in forum Spindles & Drive Motors
    Replies: 19
    Last Post: 15-05-2013, 08:00 PM
  3. huanyang vfd 2.2 error E.CO.A
    By edgas10 in forum General Electronics
    Replies: 0
    Last Post: 01-07-2012, 08:12 PM
  4. PDA Controlling A Steeper Motor
    By ceaser in forum Stepper & Servo Motors
    Replies: 5
    Last Post: 23-05-2009, 03:03 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules