Thread: eazicnc 3 'SAFETY' message
Threaded View
-
09-10-2011 #1
Hi All,
I have a yellow 'SAFETY' message appear on the right hand side of the 'machine' window in eazicnc 3 just above the MDI window. Normally it is a green 'OK'. I have just pinched nut up, taken rocking out out of main spindle bearings. Spindle still turns freely. Any ideas?
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
DIY CNC Safety Guide
By tati in forum Gantry/Router Machines & BuildingReplies: 0Last Post: 12-08-2013, 12:02 PM -
Message for member SMASH
By birchy in forum General DiscussionReplies: 1Last Post: 07-08-2013, 09:40 AM -
Add Operator Message in G-code?
By Tenson in forum Programmers CornerReplies: 6Last Post: 07-02-2013, 07:39 PM -
Eazicnc on denford easiturn
By pistolknight in forum Denford LathesReplies: 2Last Post: 24-11-2011, 07:55 PM -
eazicnc v mach3
By coldrain in forum Artsoft Mach (3 & 4)Replies: 8Last Post: 01-02-2011, 03:33 PM
Bookmarks